Useful Adjustment Settings; Switching The Vertical Drive Mode (Av Source Only); Adjusting Image Positions (Av Source Only); Adjusting Image Positions And Clock Automatically (Pc Source Only) - Pioneer PDP-LX608G Manual De Instrucciones

Useful adjustment settings

Chapter 9
Useful adjustment settings
About "Option" menus
The "Option" menu consists of two screens. To select the desired
menu, press repeatedly / to switch between Screen 1 and
Screen 2. The current screen number appears at the top right
corner on the screen.
Option
Position

Auto Size

Side Mask

HDMI Input

HDMI Control Setting

Blue LED Dimmer

Orbiter

Video Pattern

Option

Drive Mode

Color System

Monitor Out

Game Control Pref

Room Light Sensor

Switching the vertical drive mode
(AV source only)
You can select the desired drive mode according to the program
you watch.
1 Press HOME MENU.
2 Select "Option" (/ then ENTER).
3 Select "Drive Mode" (/ then ENTER).
4 Select "1", "2" or "3" (/ then ENTER).
5 Press HOME MENU to exit the menu.
Note
• This setting can be made for each input source separately.
• Selections are effective only for the following input signals:
PAL/SECAM, 576i, 576p, 1080i@50 Hz, 720p@50 Hz.
• This setting cannot be made when 480i, 480p, 1080i@60 Hz,
720p@60 Hz, 1080p@24 Hz or 1080p@60 Hz signals are input.
• The Drive Mode does not operate when "On" is selected in
"Game Control Pref".

Adjusting image positions (AV source only)

Adjust the horizontal and vertical positions of images on the
plasma television.
1
1/2
2
3
Off
4
5
position (/).
6
Auto
On
• To restore the factory defaults for all items, press / to select
2/2
1
• Adjustments are stored separately according to input source.
Auto
• Depending on the displayed video, the image position may not
Always Output
Off
• When "Dot by Dot" is selected for the screen mode, the
On
Adjusting image positions and clock
automatically (PC source only)
(For AV source)
Use Auto Setup to automatically adjust the positions and clock of
images coming from a personal computer.
1
2
3
• A message screen appears and Auto Setup starts.
4
• When Auto Setup is finished, "Auto Setup completed."
• Even when "Auto Setup completed." appears, Auto Setup may
• Auto Setup may fail with a PC image composed of similar
• Be sure to connect the computer to the plasma television and
• This function is not selectable when the PC is connected to the
• Depending on the displayed video, the image position may not
Press HOME MENU.
Select "Option" (/ then ENTER).
Select "Position" (/ then ENTER).
Select "H/V Position Adjust" (/ then ENTER).
Adjust the vertical position (/) or the horizontal
Press HOME MENU to exit the menu.
Note
"Reset" in step 4, and then press ENTER. A confirmation screen
appears. Press / to select "Yes", and then press ENTER.
change even after adjustment.
"Position" menu is dimmed.
Press HOME MENU.
Select "Option" (/ then ENTER).
Select "Auto Setup" (/ then ENTER).
Press HOME MENU to exit the menu.
Note
appears.
have failed, depending on conditions.
patterns or monochrome. If not successful, change the PC
image and try again.
switch it on before starting Auto Setup.
HDMI terminal.
change even after adjustment.
09
37
En