Shure AD4Q Manual De Instrucciones página 28

Wireless Workbench (WWB) software provides comprehensive control for wireless audio systems. Wireless Workbench
enables remote adjustments to networked receivers for real-time changes to gain, frequency, RF power, and control locks.
A familiar channel strip interface displays audio meters, transmitter parameters, frequency settings, and network status.
Dante
The Dante Controller is a free software program created by Audinate to configure and manage networks of Dante-
enabled devices. Use the Controller to create audio routes between networked components and to monitor the status of
online devices.
Dante Controller and Lock Settings
Version 1.2.X introduces support for Dante Device Lock for AD4D and AD4Q. Dante Device Lock is a feature of Dante Contro­
ller that allows you to lock and unlock supported Dante devices using a 4-digit PIN (Personal Identification Number). When a
device has a Dante lock turned on, Dante audio will continue to flow according to existing subscriptions, but its subscriptions
and settings can't be controlled or configured.
If you forget your Dante Device Lock PIN, see the Device Lock section of the Dante Controller User Guide for instructions on
how to proceed.
Dante Domain Manager
Version 1.2.X introduces support for Dante Domain Manager (DDM) for AD4D and AD4Q. DDM is network management soft­
ware that enables user authentication, role based security, and audit capabilities for Dante networks and Dante­enabled pro­
ducts.
Considerations for Shure devices controlled by DDM:
• When you add Shure devices to a Dante domain, leave the local controller access setting in Read Write. Otherwise, ac­
cess to Dante settings, device factory reset, and device firmware updates will be disabled.
• When a device is managed by a Dante Domain and the Dante Domain is disconnected, access to Dante settings, device
factory reset and device firmware updates will be disabled. When a device reconnects to the Dante Domain, it follows the
policy set for it in the Dante Domain.
See the Dante Domain Manager User Guide for more information.
Networking Modes and Switch Configuration
The receiver offers two selectable networking modes:
• Split/Redundant: This mode places Dante audio and Shure control on separate networks, while allowing you to take ad­
vantage of Dante redundancy.
• Switched: In Switched mode, the receiver acts as a 4-port network switch. Shure control and Dante audio are present on
all network ports.
™
Shure Incorporated
28/44