Dreame Bot D10S Plus Manual Del Usuario página 15

Specifications
EN
Robot
Model RLS6AD
Charging Time Approx. 6 hours
Rated Voltage 14.4 V
Rated Power 46 W
Operation
2400-2483.5 MHz
Frequency
Maximum
＜ 20 dBm
Output Power
24
Auto-Empty Base
Model RCS2
Rated Input 220-240 V 50-60 Hz
Rated Output 19.8 V 1 A
Rated Power 800 W
Under normal use of condition, this equipment should be kept a
separation distance of at least 20 cm between the antenna and
the body of the user.
Battery Disposal and Removal
The built-in lithium-ion battery contains substances that are
hazardous to the environment. Before disposing of the battery,
make sure the battery is removed by qualified technicians and
discarded at an appropriate recycling facility.
• the battery must be removed from the appliance before it is
scrapped;
• the appliance must be disconnected from the supply mains when
removing the battery;
• the battery is to be disposed of safely.
CAUTION:
• Before removing the battery, disconnect the power and run out
the battery as much as possible.
• Unneeded batteries should be discarded at an appropriate
recycling facility.
• Do not expose to high temperature environment to avoid risks of
explosion.
• Under abusive conditions, liquid may be ejected from the battery.
If contact occurs, flush with water and seek medical help.
WEEE Information
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with
unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated
collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and
recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for
more information about the location as well as terms and conditions of such collection points.
Removal Guide
1. Turn over the robot, use a proper tool to remove the screws on
the back of the robot, and then remove the cover.
2. Unplug the terminals between the battery and PCB board to
remove the battery.
EN
25