Dreame Bot D10S Plus Manual Del Usuario página 8

Before Use
EN
1. Remove the protective strips
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
10
3. Connect to a power outlet and start charging
Place the base on level ground against the wall and connect it to
a power outlet. Place the robot onto the base to charge. The robot
will turn on automatically and begin charging. It is recommended
to fully charge your robot before first-time use.
> 0.3 m
Within the Good
Wi-Fi Range
> 0.5 m
> 0.5 m
Put away the power cord
> 1.5 m
into the cord storage slot
Note:
· Keep the immediate area 1.5 m in front of the base and 0.5 m to its both
sides clear of objects.
· Make sure that no objects might block the signaling area.
About the Auto-Empty Base
It is recommended that the robot set out from the base before cleaning. Do not
move the base while the robot is cleaning. This ensures that the robot returns to
base smoothly.
After the robot completes the cleaning task and automatically returns to the
base, the base will start auto-empty. More settings can be operated on the app.
Connecting with the Dreamehome App
This product works with the Dreamehome app, which can be used to control your device.
1. Download the Dreamehome App
Scan the QR code on the robot, or search "Dreamehome" in the
app store to download and install the app based on your needs.
Under the
Cover
2. Add Device
Open the Dreamehome app, tap " " in the upper right, and then
scan the QR code above again to add "DreameBot D10s Plus".
Please follow the prompts to finish the Wi-Fi connection.
Note:
· Only 2.4 GHz Wi-Fi networks are supported.
· Due to upgrades in the app software, the actual operations may be different from the
statements in this manual. Please follow the instructions based on the current app
version.
3. Reset Wi-Fi
Simultaneously press and hold the buttons and until you
hear a voice say, "Waiting for the network configuration." Once the
Wi-Fi indicator is blinking slowly, the Wi-Fi has been successfully
reset.
Wi-Fi Indicator
·Blinking slowly: To be connected
·Blinking quickly: Connecting
·On: Connected
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and add the
device again.
EN
11