Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL START OF THE STORAGE CYCLE
Should it become necessary to start the storage cycle manually, you can do this at any time. Keep paddle button
•
(2) and compressor button (1) pressed simultaneously for 3 seconds. The machine will immediately switch to
storage cycle related to the classic Italian gelato production program. The LED (12a) will turn on.
Should you need to run a storage cycle related to a different production program, before switching from manual
•
mode to storage mode, select the desired production program (see section "CHANGING THE STORAGE
CYCLE").
AUTOMATIC MODE
The GELATO 5+5KTWIN CREA I-GREEN machine has a series of programs which automate the production and
storage process.
• Follow the steps described in the section "HOW TO USE ".
Press button (11) to start up the machine in automatic mode by selecting the first operation program. The LED
•
flashes for 3 seconds during which, if you keep on pressing the button (11), you will be able to select other
programs in sequence.
When the led light becomes stable, the relative program starts and the production cycle begins
•
The machine has 4 production programs and 4 storage cycles for each of them. When the program selected starts
•
up you can choose the storage cycle desired. Chose the storage cycle by pressing the button (12) repeatedly.
When switching from the first storage program to the fourth, gelato consistency increases gradually.
When the gelato reaches the right consistency, the production program stops automatically and the preset
•
storage cycle is enabled.
Each production program has a predetermined time limit, after which the machine goes automatically in storage
•
function. If deemed appropriate, it is possible to terminate the production program and activate the storage cycle
at any time. Press and hold the (2) and (1) buttons simultaneously for 3 seconds. The machine will immediately
pass from the production cycle to the storage cycle. Select the desired storage cycle by pressing key 12 (selection
in sequence).
CLASSIC ITALIAN GELATO AND SORBET PROGRAM. By pressing button (11) once, the LED (11a) will light up
and activate the production program. At the end of the production cycle, the LED (11a) flashes indicating that the
selected storage cycle has been activated.
If the preparation was ready before reaching the operation time limit, the whipping paddle locks. The storage function
is automatically activated.
SEMI-SOFT GELATO PROGRAM. By pressing button (11) twice, LED (11b) will light up and activate the processing
program. At the end of the production cycle, the LED (11b) flashes indicating that the selected storage cycle has been
activated.
If the preparation was ready before reaching the operation time limit, the whipping paddle locks. The storage function
is automatically activated.
GRANITA PROGRAM. By pressing button (11) three times causes LED (11c) to light up and activate Granita
processing. At the end of the production cycle, the LED (11c) flashes indicating that the selected storage cycle has
been activated.
If the preparation was ready before reaching the operation time limit, the whipping paddle locks. The storage function
is automatically activated.
FAST COOLING PROGRAM. Pressing button (11) four times causes LED (11d) to light up and activate the fast
cooling program. At the end of the production cycle, the LED (11d) flashes indicating that the selected storage cycle
has been activated.
This program is used when processing mixtures with high initial temperatures. The program quickly brings down the
temperature without adding too much air into the mixture, saving time and improving the quality of the gelato made.
CHANGE IN THE SELECTED PROGRAM
Should it become necessary to select a different program when a program is running, you can simply press button
(11). When the new program is selected, the currently running program will stop. The new program will be start
immediately with its own execution times that will restart from the initial values.
10
English
Publicidad
