Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
If replacing the battery while the UPS is connected to the DIN rail, be sure to maintain at least 10" of clearance
above the UPS. If removing the UPS from the DIN rail be sure to disconnect all connections prior to removing
the UPS.
1.
Remove battery cover and screws, set them aside in a safe place to avoid dropping screws inside the UPS.
Disconnect the battery terminal wires from the battery. Safely secure the wires so that the battery can be
lifted from the UPS without obstruction.
2.
Carefully remove the battery from the UPS.
Position the battery cables so they will not be pinched when the new battery is installed in the UPS and the
cover is screwed back on.
3.
Carefully slide the new battery into the UPS. Connect the battery wires firmly to the new battery terminals;
black to negative (–) followed by red to positive (+).
4.
Use the screws removed in step 1 to re-install the cover to the battery compartment.
5.
Power the UPS back on.
5 5 . . 2 2
S S t t o o r r a a g g e e
Ambient temperature range is 5°F to 140°F (-15°C to 50°C). It is recommended to charge the UPS for at least 8
hours, then store the UPS covered and upright in a cool, dry location. Remove accessories and disconnect
cables connected to the UPS to avoid unnecessary draining of the battery.
E E x x t t e e n n d d e e d d S S t t o o r r a a g g e e
During extended storage in environments where the ambient temperature is 5°F to 86°F (-15°C to 30°C),
charge the UPS battery every six months.
During extended storage in environments where the ambient temperature is 86°F to 113°F (30°C to 45°C),
charge the UPS battery every three months.
5 5 . . 3 3
R R e e c c y y c c l l i i n n g g t t h h e e U U s s e e d d E E q q u u i i p p m m e e n n t t
Contact your local recycling or hazardous waste center for information on proper disposal of the used
equipment
Eaton Din Rail UPS Advanced User Guide 9340AC—Rev A
14
RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk of electric
shock symbol.
This symbol indicates that you should not discard the product in the trash. This product
must be disposed of properly. For more information, contact your local recycling/reuse or
hazardous waste center.
This symbol indicates that you should not discard waste electrical or electronic
equipment (WEEE) in the trash. For proper disposal, contact your local recycling/reuse or
hazardous waste center.
Publicidad
