Publicidad
Idiomas disponibles
Idiomas disponibles
08. Using Uniwand
1.
Clean the area of the face you wish to treat.
2.
Connect the Uniwand lead into either lead
socket on the Uniglo device.
3.
Apply the Unigel Hyaluronic Conductive Gel to
the facial area. Use a similar amount as if you
are applying moisturiser to your face.
4.
Turn on the Uniglo device.
5.
Press the programme button until
FACE 2 programme has been selected.
Once selected, the treatment session
will automatically start.
6.
Perform the facial strokes for the selected area
of the face, as indicated in the facial strokes
diagrams. Each facial stroke should take 5
seconds to perform.
For each phase of the Uniglo programme, the user
should complete a set of facial stroke cycles.
Phase 1 – 2 cycles
Phase 2 – 3 cycles
Phase 3 – 2 cycles
•
1 stroke = a facial stroke from one starting
position
•
1 cycle = facial strokes from each starting
position (see facial stroke diagrams), for both
sides of the face
•
1 phase = one part of the facial treatment with a
set number of cycles to complete.
15
Publicidad
