Vortice CA MD RF EP Manual De Instrucciones página 9

ENgLISH
Description and operation
The appliance you have purchased is a roof-mounted
centrifugal fan designed to extract air freely or through
a ventilation duct.
These appliances are designed
•
for use in
commercial properties.
Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
Safety
• Do not use this appliance for functions other than
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician or
Vortice. Do not leave packaging within the reach of
children or infirm persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
- never touch electrical appliances with wet or damp
hands;
- never touch appliances while barefoot;
- never allow children or infirm persons to operate
appliances unattended.
This appliance can be used by
•
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
Children shall not play with the
•
appliance.
Cleaning and user maintenance
•
shall not be made by children
without supervision.
residential and
• Store the appliance out of the reach of children and
differently able persons after deciding to disconnect
it from the power supply and use it no more.
• Do not us the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
Precautions must be taken to
•
prevent gas coming from the gas
flue pipe or from other fuel
combustion units from entering
into the room.
Products installed without a
•
protective device for moving
parts must be installed at a
height greater than 2.3 m above
the floor level. (Fig.7)
Units equipped with manual
•
reset thermal breaker device
In order to avoid any danger of
accidental reset of the thermal
breaker device, units must not be
powered by an external switch
device such as a timer, or must
not be connected to a circuit that
is regularly
disconnected from power utilities
powered or
9