Trouble Shooting Guide - Altrad Belle RPC 45 Manual Del Operador

Problem
Engine will not start.
Engine still will not start.
Unit will not move.
Forward speed too slow.
Reverse speed too slow.
Loss of Hydraulic Oil.
Machine operates
erratically.

Trouble Shooting Guide

Cause
No fuel.
Engine switched off.
Spark plug fouled.
Engine cold.
Engine ooded.
Major Fault.
Engine speed too slow.
Drive belt tension loose.
Air lter blocked.
Worn or Damaged Clutch.
Drive failure.
Gearbox failure.
Too much oil in hydraulic head.
Wrong adjustment of control system
Not enough oil in hydraulic head.
Air in control system.
Wrong adjustment of control system
Connectors leaking.
Defective hydraulic hose.
Piston seal in gearbox defective.
Shock mounts damaged.
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean and reset plug gap.
Close choke.
Honda, open choke, fully open throttle, pull recoil starter
until engine res.
Hatz, move speed control to stop, pull recoil starter 5 times
then repeat start procedure.
Contact Agent or Altrad Belle.
Set engine speed control to fast.
Adjust belt tension
Clean or renew air lter.
Repair or Replace as necessary.
Contact Agent or Altrad Belle.
Contact Agent or Altrad Belle.
Reduce oil level.
Contact Agent or Altrad Belle.
Fill and bleed system.
Bleed control system.
Contact Agent or Altrad Belle.
Reseal connectors.
Replace hose.
Contact Agent or Altrad Belle.
Replace all four mounts.
19