Cameo OTOS SP6 Manual De Usuario página 26

Hold
Last Stand Alone
Fade to Black
Signal
(10s)
Fail
Blackout
Full
Sun Protection
User A
Store
User B
Default
User C
SERVICE MENU
Starting from the main display, press MENU to enter the main menu. Select Service using  and
 and confirm with ENTER.
Information on the submenu items in the service menu and the corresponding options can be
found in the table below (select with  and  confirm with ENTER, change value or status with
 and  confirm with ENTER).
Service
Factory
User A
Load Default
User B
User C
Pan / Tilt
Reset Head
All
Test Sequence
Test
Stress Test
26
Last command is maintained if the control signal is interrupted
In case of control signal interruption, the last activated stand-
alone operation is started
In case of control signal interruption, fade out to blackout takes
place for 10 seconds
Instant blackout if the control signal is interrupted
Full On on control signal interruption
Function is activated in case of signal failure
Save user settings A
Save user settings B
Save user settings C
Reset to factory setting
Reset to User A values (save user values: Settings -> Set
Def. values)
Reset to User B values (save user values: Settings -> Set
Def. values)
Reset to User C values (save user values: Settings -> Set
Def. values)
Resets pan / tilt motors
Resets motors in the device head
Resets all motors
Pre-programmed sequence to test all components
Pre-programmed sequence to test all components under
maximum load