Publicidad
Idiomas disponibles
Idiomas disponibles
4
Mounting
5
Electrical installation
8025303.1DTW /2022-02-14 | SICK
Subject to change without notice
Table 8: Operating elements and status indicators
WLD4FP-
xxxxxx30A00
Teach-in button
1
2
4 3
BluePilot blue: alignment aid
1
Teach-Button: adjusting the sensitivity
2
Yellow LED: status of received light beam
3
Green LED: supply voltage active
4
Mount the sensor and the reflector using suitable mounting brackets (see the SICK
range of accessories). Align the sensor and reflector with each other.
Note the sensor's maximum permissible tightening torque of < 0,4 Nm.
Operation in standard I/O mode:
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
–
Male connector connection: Pin assignment
–
Cable: Wire color
Only apply voltage/switch on the voltage supply once all electrical connections have
been established.
Operation in IO-Link mode: Connect the device to a suitable IO-Link master and inte‐
grate in the master or controller via IODD/function block. The green display LED flashes
on the sensor. IODD and function block are available to download from
under the part number.
Explanations on connection diagram.
BN = brown
WH = white
BU = blue
BK = black
MF (pin 2 configuration) = external input, teach-in, switching signal
Q
/C = switching output, IO-Link communication
L1
Test = Test input
U
: 10 ... 30 V DC
B
PRODUCT DESCRIPTION
xxxxxx00A00
No possibility of setting
No possibility of setting
1
4 3
O P E R A T I N G I N S T R U C T I O N S | WLD4F
3
xxxxxxA0Zxx
4
3
en
www.sick.com
21
Publicidad
