Publicidad
Idiomas disponibles
Idiomas disponibles
5. How to use the accessories
Wallpaper remover
The wallpaper remover is available as a special
accessory (see page 27 for the order number).
You can use the wallpaper remover with the
steam cleaner to remove wallpapers.
• Place the entire surface of the wallpaper
remover along the edge of a strip of wallpaper.
Switch on the steam supply (C5) and allow the
steam to act on the wallpaper until it is
completely soaked (approximately 10
seconds).
• Move the wallpaper remover to the next piece
of wallpaper you want to remove. Hold the
steam switch (C5) pressed while you move the
tool. Lift the soaked piece of wallpaper using a
flat trowel, and pull it off the wall. Move the
wallpaper remover from strip to strip, and pull
the wallpaper off in strips.
• In case of woodchip wallpaper that has been
painted several times, the steam may not be
able to soak the wallpaper. Thus, we
recommend to prepare the wallpaper using a
spiked roller before steam is applied.
Steam rotary nozzle
The steam rotary nozzle is available as a
special accessory (see page 27 for the order
number).
Fields of application:
– cleaning of corners, joints
– areas that are difficult to access
24 – English
6. Care & maintenance,
Cleaning the boiler
Always disconnect the mains plug and allow the
steam cleaner to cool down before performing any
maintenance work.
Rinsing the boiler
If your tap water is harder than 10 degrees of
German hardness (=°dH), i.e. hardness class II,
rinse the boiler of the steam cleaner at the latest
after having filled it with water five times. If the
water is softer, you should rinse the boiler at the
latest after having it filled 15 times. Please
contact your Conservancy Board or the local
water supply company to inquire about the
hardness of your water.
• Fill the boiler with water and shake it
vigorously. This will loose any limescale that
has built up on the bottom of the boiler. Tilt the
appliance towards the edge with the funnel
inlet and pour the water out (see Figure 13).
Figure 13: Rinsing the boiler
Descaling the boiler
As limescale also builds up on the boiler walls,
we recommend to descale the boiler in the
following intervals (TF=boiler fillings):
Degree of hardness
soft
I
II
medium
III hard
IV very hard
Table 1: Cleaning interval of the boiler
• Disconnect the steam cleaner from the
electrical mains.
• Make sure that no water is left in the boiler (see
Figure 13).
Only use products approved by Kärcher to exclude
any damages of the appliance.
• For descaling, use Kärcher bio-descaler RM
511 (manufacture no. 6.295-075). When using
the descaling solution, mind the dosing
instructions on the packaging.
° dH
mmol/l
0 – 7
0 – 1,3
7 – 14
1,3 – 2,5
14 – 21
2,5 – 3,8
> 21
> 3,8
SC 1702
TF
100
90
75
50
Publicidad
