Kärcher IV 100/40 Manual Original página 19

1 Handle for filter cleaning
2 Spring
3 Fastener for filter dedusting
4 Lock
5 Lid of filter chamber
 Tilt the fastener for filter dedusting to-
wards the side.
 Unscrew the handle for cleaning the fil-
ter.
 Remove the spring.
 Unscrew the nut below the spring (you
will need a spanner with width 27 mm).
 Open locks.
 Remove the lid of the filter chamber.
1 Frame
2 Filter
 Open the knot of the tapes on the filter
and remove the frame.
 Take out the filter.
 Insert and secure the new filter in the re-
verse sequence of steps.
IV 100/75
 Press the "Switch off appliance" switch.
 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
 At the lower end, loosen and pull out the
hose to the suction turbine.
 Open locks.
 Remove the lid of the filter chamber.
1 Knurled head screw
 Turn out both the knurled head screws
and remove the filter from the appli-
ance.
 Insert and secure the new filter in the re-
verse sequence of steps.
– 7
EN 19