Roadstar HRA-270CD+BT Manual De Instrucciones página 7

English 4
DAB RADIO OPERATION
Switch to DAB mode
Press [SCAN] button (10) to activate a full station search. A progressive bar will show
the progress of the scan and the number of stations found during the scan. The sta-
tions scanned will be stored automatically when the scan is complete.
The first station available will be played automatically.
You can rotate [SELECT] knob (10) to switch among stations stored.
Rotate [SELECT] knob (10) clockwise or anticlockwise to seek for your favorite sta-
tions. Press [SELECT] button (10) to confirm.
PRESET STORE
To store a station preset , you must first tune to the station you wish to set as a pre-
set. Then press [PRESET] (7) button to activate store function. "01. Empty-20.Empty"
will be displayed on the screen, rotate [TUNE] knob (10) to scroll through the num-
bered preset locations (1-20), press and hold [TUNE] knob (10) to store the station.
"Preset x Saved" will be shown on the screen to indicate after you store the station
successfully. 20 stations can be stored in total. To tune to a preset DAB station, press
"Preset", use [TUNE] knob (10) to scroll through the preset stations.
Press [TUNE] (10) button or wait a few seconds to confirm when you see the station
you would like to listen. The radio will begin to play. If you have already saved a sta-
tion in that preset position , the new selection will override the previous saved station.
In DAB mode, press "INFO" button, the information such as DLS, station name, time
and date, frequency, bit rate, signal quality will be displayed.
Note: For a better reception reorient the antenna (14).
FM RADIO OPERATION
Press [FUNCTION] button (3) and switch into FM mode.
To scan stations manually, rotate [SELECT/SNOOZE/TUNE] knob (10) to adjust sta-
tions by 0.05MHZ until you get your favorite stations.
To auto scan stations, short press [SCAN] (10) button to search stations , if station
signal is available, scan will stop automatically and the radio will play this station.
Long press [SCAN] (10) button , it will activate a full station search. A progressive bar
will show the progress of the scan and the number of stations found during the scan.
The stations scanned will be stored automatically when the scan is complete. Long
press "Preset " button , you can rotate [SELECT] knob (10) to switch among stations
stored.
To store a station preset, see PRESET STORE setting.
INFO
When the radio station is playing, press the [INFO] button (8) repeatedly to cycle
through the information broadcasted by the radio.