Descargar Imprimir esta página

Philips HomeRun Aqua 7000 Serie Manual De Instrucciones página 37

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 186
Problem
The robot uses no or little
water during mopping.
Too much water comes out
of the mop / the robot
makes the floor too wet.
Robot misses areas for
cleaning/ robot does not
clean the whole area/ robot
has began to miss certain
spots
The robot has blocked itself
by eating a cable.
Possible cause
Obstacles are stuck in the
brushes.
The filter has not been cleaned. Clean the filter regularly.
The filter has not been placed
back or has not been placed
back correctly.
The washable mop needs to be
replaced.
The water level is set too low.
The water level is set too high.
The sensors of the robot are no
longer clean.
The robot is working on
slippery polished floors.
The robot is unable to reach
certain areas blocked by
furniture or barriers.
The cleaning area is not tidy.
The robot keeps a safety
margin in the distance close to
No-Go zones and No-Mop
zones, and this can cause that
the robot won't pass a certain
area.
There are cables on the floor
which the robot is unable to
detect.
Solution
Remove all obstacles from the brushes.
Place the filter back correctly.
Replace the XV1470 washable mop.
Purchase a new XV1470 washable mop via
de app or on
www.philips.com/myrobot7000
Set the water level higher in the app.
Set the water level lower in the app.
IMPORTANT: For mopping sensitive hard
floors, such as parquet floors, set the water
level in the app to the lowest level.
Clean the robot's sensors with a dry cloth.
Make sure the floor is dried before the
robot starts cleaning.
Tidy up the area to be cleaned by putting
furniture and small objects in their proper
place.
Remove small objects from the floor and
tidy up the cleaning area before the robot
starts cleaning.
Make the No-Go zone or No-Mop zone in
the app a bit smaller.
Stop the robot and remove the brush cover.
Take away main brush and check if
something is stuck in the side brush:
remove side brush, take away the cable,
reattach the side brush. Remove all cables
from the floor before you start a cleaning
run.
English
39

Publicidad

loading