Selco WF 2000 Classic Instrucciones De Uso página 32

E49 Emergency switch alarm
E50 Wire stuck alarm
E51 Unsupported settings alarm
E52 Anti-collision alarm
E53 External flow switch alarm
E99 General alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
E56 Voltage level exceeded (Alarm)
E64 Voltage level exceeded (Warning)
E57 Voltage level exceeded (Alarm)
E65 Voltage level exceeded (Warning)
E60 Speed limit exceeded
E68 Speed limit exceeded
E61 Speed limit exceeded
E69 Speed limit exceeded
E70 Incompatible "WARNING" alarm
E71 Liquid coolant overtemperature alarm
32
(Alarm)
(Warning)
(Alarm)
(Warning)
3.5 Rear panel
1 Gas fitting
2 Signal cable input (cable bundle)
3 Power cable input (cable bundle)
4 Cooling liquid inlet/outlet
5 External devices (RC)
3.6 Sockets panel
1 Torch fitting
Permits connection of the MIG torch.
2 Signal cable input (U/D)
3 Cooling liquid connection
4 Positive power socket (MMA)
5 Gas flow regulator
4 ACCESSORIES
4.1 General
Operation of the remote control is activated when connected
to the Selco power sources. This connection can be made also
with the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.