Breville the Barista Touch Impress Manual De Instrucciones página 26

Troubleshooting
PROBLEM
Water does not flow
from the group head
No hot water
No steam
The machine is ON
but ceases to operate
Coffee runs out too
quickly
Coffee runs out slowly
Coffee is too cold
No crema
26
POSSIBLE CAUSES
•
Water tank is empty.
•
Water tank is not fully inserted
and locked into position.
•
Water tank is empty.
•
Steam wand is blocked.
•
The coffee grind is set too coarse. Adjust the grind size to a lower setting.
•
Not enough ground coffee in
the filter
•
The coffee grind is set too fine.
•
Excessive dose in the filter.
•
Cups not preheated
•
Milk not heated enough (when
making a milk based drink)
•
Coffee beans are stale
WHAT TO DO
Fill tank.
Push water tank in fully and lock latch closed.
Fill water tank.
Use the pin on the end of the provided
cleaning tool. If steam wand remains blocked,
remove the tip using the integrated spanner
in the cleaning tool and soak in hot water.
Screw tip back onto the steam wand using the
integrated spanner in the cleaning tool.
Turn machine off. Wait for 60 minutes and
turn machine back on. If problem persists,
call Breville Consumer Support.
Refer to 'Setting The Grind Size And Dosing'
Functions.
under
Adjust the grind size to a higher setting.
Refer to 'Setting The Grind Size And Dosing'
Functions.
under
Pre-heat cups
Check selected milk temperature setting.
Use freshly roasted coffee beans with a
'Roasted On' date and consume between
5-20 days after that date.