Johnson MISTRAL Serie Manual De Instrucciones página 33

Table 7-1
AIR FLOW(m
POWER
FREQUENCY AND VOLT
CIRCUIT BREAKER/FUSE(A)
INDOOR UNIT POWER
WIRING(mm 2 )
GROUND WIRING(mm
The power cord type designation is H05RN-F or above.
7.2 Wiring figure
If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a hazar
installation manual
8
3 /h)
PHASE
BELOW 20M
BELOW 50M
2
)
NOTE
510~2550
1-phase
220-240V~ 50Hz
15/15
2
Twisted pairwire 2.5mm
2
Twisted pairwire 6mm
2.5
8. TEST OPERATION
1
The test operation must be carried out after the entire
installation has been completed.
2 Please confirm the following points before the test operation:
The indoor unit and outdoor unit are installed properly.
Tubing and wiring are correctly completed.
The water pipe system is leakage-checked.the drainage is
unimpeded.
The heating insulation works well.
The ground wiring is connected correctly.
The length of the tubing has been recorded.
The power voltage fits the rated voltage of the air
conditioner.
There is no obstacle at the outlet and inlet of the outdoor
and indoor units.
The air conditioner is pre-heated by turning on the power.
According to the user's requirement, install the remote
3
controller frame where the remote controller's signal can
reach the indoor unit smoothly.
Test operation
4
Set the air conditioner under the mode of "COOLING" with the
remote controller, and check the following points. If there is
any malfunction, please resolve it according to the chapter
"Troubleshooting" in the "Owner's Manual".
a. Whether the switch on the remote controller works well.
b. Whether the buttons on the remote controller works
well.
c. Whether the air flow louver moves normally.
d. Whether the room temperature is adjusted well.
e. Whether the indicator lights normally.
f. Whether the temporary buttons works well.
g. Whether the drainage is normal.
h. Whether there is vibration or abnormal noise during
operation.
I. Whether the air conditioner heats well in the case of the
HEATING/COOLING type.
A protection feature prevents the air conditioner from being
activated for approximately 3 minutes when it is restarted
immediately after shut off.
V.1
CAUTION