vitra. Playns Cluster Istrucciones Para El Uso página 10

Memory Function
Container stop and shelf stop
These functions can be used to limit the distance the table will go up or down, e.g. if there is a container beneath the table.
Note: The container stop position can only be saved in the lower half of the table's movement range and the shelf stop position can only be saved in the
upper half of its movement range.
Saving a container stop or shelf stop position
Using the up or down key, raise or lower the table to achieve the desired position of the new container stop or shelf stop position.
Press the S key. The display will show «S -».
Within the next 5 seconds, press the up key and hold it for at least 5 seconds. An audible double click will confirm that the saving procedure was
successful.
Deleting a container stop or shelf stop position
Using the up or down key, raise or lower the tabletop to the upper half or lower half of its movement range.
Press the S key. The display will show «S -».
Within the next 5 seconds, press the down key and hold it for at least 5 seconds. An audible single click will confirm that the deleting procedure was
successful.
Reverse cm(S 1)/Zoll(S 5)
Simultaneously press the 1, 2 and up keys. Hold them for about 3 seconds. The display will show «S 1».
Keep the keys pressed until the display shows «S 5».
Then press the S key.
10
71025966GA52S210x148K120PAYCluster_EN_DE_FR_ES.indd 10 21.07.2011 19:47:52