Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Error
Motor, transformerTelescopic guide
or handset
does not work
Table can no longer be driven
upwards
The display will show «HOT».
The display shows «E» followed by
an error code.
The display shows the error code
«E 81».
The display shows the error code «E
55» or «E 56».
The display shows the error code
«E 67».
12
71025966GA52S210x148K120PAYCluster_EN_DE_FR_ES.indd 12
Cause
Remedy
Bad plug contact
Contact your Vitra specialist retailer.
Motor faulty
Contact your Vitra specialist retailer.
Transformer faulty
Contact your Vitra specialist retailer.
Handset faulty
Contact your Vitra specialist retailer.
Feeder line faulty
Contact your Vitra specialist retailer.
1. Turn off the power to the unit and wait 1–2 seconds before turning it back on.
2. see Commissioning and Reset
Power failure
see Commissioning and Reset
Overheating will activate the
Wait until the motor control unit has cooled down and the display no longer
overheating protection.
shows «HOT».
The motor control unit is then ready for operation again.
Internal error
Contact your Vitra retailer.
Internal error
1. Reset the unit.
2. Turn off the power to the unit and wait 1–2 seconds before turning it back on.
If this error appears regularly, unplug the power cord. Contact your Vitra
retailer.
The motor groups cannot be
1. Remove all loads from the device.
synchronised.
2. Reset the unit.
Does the display still show «E 55» or «E 56»? Contact your Vitra retailer.
Voltage is too high
1. Turn off the power to the unit.
2. Contact your Vitra retailer.
21.07.2011 19:47:52
Publicidad
