Publicidad
Idiomas disponibles
Idiomas disponibles
Memory Function
Saving a position
A specific desk height (position) can be saved using this function. 4 different positions can be saved. These saved positions can be reset later(See
Adjusting the desk to a saved position).
Raise or lower the tabletop to the desired position. The current height will be shown on the display (e.g. 73 cm).
Press the Save key. The display will show «S –» (e.g. 2).
Press the desired save position number. The display will show «S 2».
An audible double click will confirm that the saving procedure was successful.
After about 2 seconds, the saved tabletop height will be shown (e.g. 73 cm).
Adjusting the desk to a saved position
Press and hold 1, 2,3 or 4 until the desk stops on its own.
Note: If the position key is released before the stop position is reached, the desk will remain in the current position.
Changing the height display of the tabletop position
This function can be used to change the height shown on the display but not the actual position of the tabletop (e.g. when using a different panel
thickness than foreseen in the pre-programmed information). Note that this setting change does not alter the actual position of the tabletop. It only
affects the height shown on the display.
Press the Save key. The display will show «S -».
Press the down key for about 10 seconds. The display will begin to blink.
Now set the height using the up and down keys.
Press the Save key S. The height to be shown for the current tabletop position is now set.
9
71025966GA52S210x148K120PAYCluster_EN_DE_FR_ES.indd 9
21.07.2011 19:47:52
Publicidad
