Publicidad
Idiomas disponibles
Idiomas disponibles
Air Filter Inspection and
Replacement
compres-sor heads are exposed
when filter cover is removed.
Allow compressor to cool prior to
servicing.
Do not operate the air compressor
with the air filter removed.
A dirty air filter will not allow the com-
pressor to operate at full capacity.
Keep the air filter clean at all times.
1.
Remove the air filter cover.
Air Filter
cover
ALL MAINTENANcE AND REPAIR
OPERATIONS NOT LISTED MUST
BE PERFORMED BY A TRAINED
SERVIcE TEcHNIcIAN.
cycles automatically when power
is on. When servicing, you may
be exposed to voltage sources,
compressed air, or moving parts.
Before servicing unit unplug or
disconnect electrical supply to
the air compressor, bleed tank
of pressure, and allow the air
compressor to cool.
To Replace or clean check Valve
1.
Release all air pressure from air
tank. See To Drain Tank in the
Maintenance section.
2.
Set the Auto/Off lever to "Off" and
unplug unit.
3.
Using a phillips screwdriver,
remove the air filter cover.
4.
Remove the rear shrouds using
T-20 torx wrench.
N015838
Hot surfaces.
Risk of burn.
Keep the air filter
clean at all times.
Air Filter
SERVIcE AND ADJUSTMENTS
Risk of Unsafe
Operation. Unit
2.
Remove the air filter and make
sure it is clean.
iMPOrTANT: Do not operate the
compressor with the air filter removed.
3.
If dirty, rinse air filter with warm
water and squeeze dry.
4.
Replace air filter and air filter
cover.
NOTe: If the air filter is extremely dirty
it will need to be replaced. Refer to
the Repair Parts for the correct part
number.
Air compressor Pump Intake
and Exhaust Valves
Once a year have a Trained Service
Technician check the air compressor
pump intake and exhaust valves.
Remove
5.
Using an adjustable wrench,
loosen outlet tube nut at air tank.
Carefully move outlet tube away
from check valve.
6.
Using an adjustable wrench
loosen pressure relief tube nut at
air tank. Carefully move pressure
relief tube away from check valve.
16- ENG
Remove
Publicidad
