Publicidad
Idiomas disponibles
Idiomas disponibles
Before you store the air compressor,
make sure you do the following:
1.
Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
2.
Set the Auto/Off lever to "Off" and
unplug unit.
3.
the regulator knob out and turn
counterclockwise to set the out-
let pressure to zero when
removing hose or accessories to
prevent hose backlash.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing
air to bleed from the tank until tank
pressure is approximately 20 psi.
Release safety valve ring.
6.
Drain water from air tank by open-
ing drain valve on bottom of tank.
N015838
STORAGE
Risk of Flying
Objects. Pull
18- ENG
condense in the air tank. If not
drained, water will corrode and
weaken the air tank causing a risk
of air tank rupture.
7.
After the water has been drained,
close the drain or drain valve.
NOTe: If drain valve is plugged, release
all air pressure. The valve can then be
removed, cleaned, and reinstalled.
8.
Protect the electrical cord and air
hose from damage (such as being
stepped on or run over). Wind
them loosely around the compres-
sor handle.
9.
Store the air compressor in a clean
and dry location.
Risk of Bursting.
Water will
Publicidad
