Beem 02688 Manual De Instrucciones página 25

25
Preparation
PLEASE NOTE!
• The device should only be used if it has been correctly assembled! Before each use, check
whether the filter insert and the permanent filter / the basket filter paper are inserted
correctly and whether the water tank is filled correctly!
• Do not operate the device without water. If this does happen, the device switches off
automatically. In this case, allow the device to cool down before water is poured in and the
device is used again.
• Do not use any water that has been in the water tank for longer than 24 hours.
• Never use the device without a suitable jug below the coffee outlet.
Making Coffee with Coffee Beans
1. Fill the water tank (5) (see the "Handling and Operation" chapter – "Filling the Water Tank").
2. Fill the coffee bean compartment (2) (see the "Handling and Operation" chapter – "Adding
Coffee Beans").
3. Set the grinding fineness you want (see the "Handling and Operation" chapter – "Setting the
Grinding Fineness").
4. Open the filter compartment (12) .
5. Insert a filter (see the "Handling and Operation" chapter – "Inserting the Filter").
6. Close the filter compartment.
7. Use the dial
chapter – "Setting the Number of Cups").
8. If you want, switch on the "added flavour" function with the
the "Handling and Operation" chapter – "Added Flavour" Function).
9. Press the ON / OFF button (19) to switch on the grinder and start the brewing process. The
operating lamp in the ON / OFF button and the control lamp in the dial
ground coffee is transported through the grinder shaft into the filter compartment and then
hot water is poured over it to brew it.
To end the brewing process prematurely, press the ON / OFF button. The operating lamp
in the ON / OFF button is lit constantly, the control lamp in the dial
device is switched off.
At the end of the brewing process, you will hear a beep, the operating lamp in the ON / OFF but-
ton goes out, the control lamp in the dial
es on the hotplate (14) (see the "Handling and Operation" chapter – "Keep-Warm Function").
02688_Inlay_DE-EN-FR-ES-IT_A5_V2.indb 25 02688_Inlay_DE-EN-FR-ES-IT_A5_V2.indb 25
(17) to set the number of cups you want (see the "Handling and Operation"
STARK (strong)
is lit constantly and the device automatically switch-
EN
button (16) (see
flash. Freshly
goes out and the
31.03.2022 12:16:33 31.03.2022 12:16:33