Publicidad
Idiomas disponibles
Idiomas disponibles
Quick reference
NOTES
A. Before turning power on, always check Landroid Vision is inside its working area. If not, the message "Outside working area!
Press START to reset" will be displayed. This message is also displayed when Landroid Vision is partly but not completely inside its
working area.
B. If for any reason—i.e. a party, children playing...—you want to park your Landroid Vision in the charging base: press
. Landroid Vision will go to its base and stay there. Please note Landroid Vision will now wait until the next scheduled mowing
session. If you want to re-start it at anytime, press
C. If an error repeatedly occurs in the same area of your lawn, you might have a problem with the working area so please refer to
the installation instructions and check your set up is correct with its help.
D. If your lawn is divided in two separated areas, connected by a corridor less than 3ft. (1m) wide, one of which is not provided
with the charging base: when Landroid Vision runs out of charge, take it manually to the charging base.
E. If Landroid Vision runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then
restart it. If the problem cannot be solved, please contact our Customer Service for help.
TROUBLESHOOTING
If your Landroid Vision does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer
Service.
SYMPTOM
CAUSE
The LED light on the charging
There is no power.
pile does not turn on.
Landroid Vision turns on,
Landroid Vision is searching for
but the blade disc does
the charging base.
not spin.
The blade disc is unbalanced.
Landroid Vision vibrates.
Blades may be damaged.
Landroid Vision does not work
enough hours per day to cut the
grass.
Mowing area is too big for the
size of Landroid Vision you have.
The blades are dull and not sharp. Change all the blades and screws in order to balance the bade disc.
Grass is being cut
The cutting height is set too low
unevenly.
for the length of the grass.
Grass or another object has
wrapped around the blade disc.
There is a build-up of grass in the
blade disc or motor frame box.
Recognition error
Programming error
The secondary area is
not mowed.
There are obsacles between the
RFIDs in the pathway.
Poor connection caused by
debris on the charging strip.
The charging time is
far more than the rated
The charging protection
charging time.
program is activated due to high
temperature.
then
to start your Landroid Vision.
SOLUTION
Check the charging base is connected properly to the charger
and the charger is connected to a suitable power supply.
This is normal: when Landroid Vision needs to recharge, the blade
disc does not rotate while it is searching for the charging base
automatically.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade disc.
Try adding more hours to the mowing schedule.
Try decreasing the size of the mowing area or increasing working
time.
Raise the cutting height and then gradually lower.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Remove the obstacles, such as leaves.
Make sure the RFIDs are installed correcly and reprogrammed.
Remove the obstacles.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
Place the charging base in a shady area or wait until the
temperature has cooled down.
EN
then
31
Publicidad
