Publicidad
Idiomas disponibles
Idiomas disponibles
Quick reference
SYMPTOM
CAUSE
Landroid Vision fails to charge
due to over temperature pro-
Landroid Vision shuts
tection and is powered off.
off when docking in the
charging pile.
Poor connection.
There is an obstacle in the wor-
king area.
Landroid Vision stops in
The cutting height is set too low
the working area.
for the length of the grass or the
grass is too dense.
There is an inclined obstacle on
Landroid Vision flips over.
the lawn.
Please check your router has the
correct settings.
Landroid Vision fails to
connect to the internet.
Please check whether the router
is disconnected or WIFI SSID is
changed.
Your Landroid Vision
beeps when you are
It is normal.
adjusting "month / hour /
minute".
SOLUTION
Place the charging base in a shady area or wait until the tempe-
rature has cooled down.
Check the LED light on the charging pile. Check the connection
between the contact pins located on the charging pile and the
charging strip.
Remove the obstacle from Landroid Vision's working area.
Raise the cutting height and then gradually lower.
Exclude the obstacle from Landroid Vision's working area.
Make sure your router is 2.4GHz or 5GHz. If your router has two
settings, please enable the 2.4GHz or 5GHz band.
Make sure your router is set to 802.11 mode and wireless setting
is b/g/n mixed.
Make sure your router has the SSID Broadcast function enabled
when you connect the machine with the app.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to connect Landroid
Vision to the new network.
If you have a "Fritz! box" router, please make sure activate
"Allow communication between devices in same network" in the
settings.
Make sure the router is connected and WIFI SSID is correct.
Counter clockwise the
to adjust.
EN
33
Publicidad
