Descargar Imprimir esta página

3M LAD-SAF Manual De Instrucciones página 20

Publicidad

INSTALLATION CHECKLIST
Serial Number(s):
Date Inspected:
Install Date:
Installed By:
Corrective Action/Maintenance
The Lad-Saf Flexible Cable Safety System Tag must be securely attached and fully legible. (See Figure 20) System Tag
contents are listed in Table 1.
The System Tag includes the following warning:
WARNING: Failure to heed warnings may result in serious injury or death. Manufacturer's instructions supplied
with this product at time of shipment must be followed for proper installation, use, inspection and maintenance.
Unauthorized alteration or substitution of system elements or components is prohibited. Use only with compatible
personnel protective equipment as per manufacturer's instructions. Before each use inspect system visually for
defects. Formally inspect system in accordance with instructions at least annually, or in accordance with specified
inspection criteria for the structure the system is secured to. Refer to instructions for information on periodic formal
inspections. Minimum spacing of users of this system is 20ft (6m). Do not remove this label.
A Single Point Anchor Warning is stamped on the washer at the top of Systems L1, L2, L3, CE1 and T1. See Table 1 and
Figure 21. For the M1 and M2 systems, the same information is stamped onto the D-ring bracket. See Figure 4.
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Date Of Manufacture:
Ensure all fasteners are in place and properly tightened.
Ensure the Carrier Cable is properly tensioned
Ensure the Carrier Cable does not abrade against the structure at any
point.
Ensure system information is recorded on the system label and
Inspection and Maintenance Log:
Components of the LAD-SAF system include a Radio Frequency (RFID) tag.
The RFID tag can be used in conjunction with the handheld reading device and
web based portal (3M.com/FallProtection) to simplify inspection and inventory
control, and maintain electronic records for your fall protection equipment.
20
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:

Publicidad

loading