Handicare SIMPLICITY+ Manual De Instalación página 21

b For multiple lift applications:
i Open both handset cases (Figure 58).
ii Set the dip switches on the PCB on both
handsets to the same settings – note that
the next pair of handsets will require the
dip switches to be set to a different
combination (Figure 59).
iii Press and hold the red button on the PCB
(Figure 57) – a yellow LED will illuminate
on the PCB.
iv Press any button on one handset and the
yellow light will go out.
v Programming is complete.
5 Test that the handsets have programmed
correctly by pressing the up and down button
on each and check that the lift moves in the
corresponding direction.
Fitting the handset holder
1 Fit the hand control holder to the wall in the
required position using the fixings supplied
(Figure 60).
Note: The handset can be fixed into the
holder by inserting the supplied plastic
locking section.
Programming
Figure 58
Figure 59
Figure 60
MINIVATOR SIMPLICITY + INSTALLATION MANUAL
21