Handicare SIMPLICITY+ Manual De Instalación página 9

2 With the end of the track positioned so that
it is just touching the floor ensure that the
feet are still positioned on the stair treads
as previously described (Figure 12), i.e:
a The top foot should be positioned on
the last tread.
b The middle foot should be positioned
immediately above the spliced joint.
c The bottom foot should be positioned
on the first tread.
3 Tighten the bolts on the feet (Figure 17).
SLIDETR CK ONLY
4 Position the first (fixed) foot on the second step
of the staircase. Then position and loosely fix the
second foot to the stairs, two full steps below
the track splice point (or the end of the track for
a single section track), to allow clearance when
the SlideTrack moves (Figure 18). The track
should be approximately 25mm from the nose
of the stairs.
5 Position the remaining feet on the steps and
loosely fix them to the stairs. The last foot
needs to be positioned two full steps down
from the top of the stairs, whilst the third foot
should be as close as possible to the splice.
6 The feet should sit as close as possible to the
stringer (Figure 19).
Note: Track may need to be moved out to
ensure seat clears.
7 If the track was not delivered pre-cut to the
correct length, trim the communications busbar
to the appropriate length to accommodate the
top end cap (Figure 20).
8 Clip on the stringer-side roller covers using
the tacks provided. Then, with the track in
approximately the correct position, put a screw
into each foot to stabilise the track (Figure 22).
Feet positioning
Figure 19
Figure 20
Figure 21
MINIVATOR SIMPLICITY + INSTALLATION MANUAL
9