Track assembly
7 Slide the three mounting feet on to the track
(Figure 11).
Note: See page 8 for SlideTrack positioning.
8 Position the feet in the following way
(Figure 12):
a The top foot should be positioned on the
last tread.
b The middle foot should be positioned
immediately next to the spliced joint. If the
top section is longer than the bottom then
the foot should be ABOVE the spliced joint,
if not, then the foot should be BELOW the
spliced joint.
c The bottom foot should be positioned on the
first tread.
9 Loosely tighten the feet to stop them from
moving. The feet will help to stop the track
from moving on the stairs while the next steps
are performed.
Note: If the stairlift is being fitted to a staircase
with open bannisters on the bannister side
they must be covered with a solid sheet
material for safety.
MINIVATOR SIMPLICITY + INSTALLATION MANUAL
6
Figure 11
Figure 12