AYP int_LOCK BT Manual Del Usuario página 44

4.6. Synchronising the BT remote controls
1- Place the supplied button cell inside the remote control
2- Keep the BT remote control to hand and make sure the door is closed and the lock is open.
If the BT remote control has been synchronised as the first device, it
becomes an administrator and therefore the configuration options are not
available. It is very important that the first device that you synchronise
should be a smartphone.
3- Insert the pairing tool into the synchronisation hole until you feel a slight "click" and the
LEDs light up red and sounds BIP at the same time.
4- Press any button on the BT remote control.
5- At this point, the remote control has been synchronised and is ready for use.
6- Repeat the process to synchronise each BT remote control.
NOTE: The synchronisation process takes a certain length of time. When it ends
you will hear a signal and the LEDs will light up.
44