SICK HL18 Manual De Instrucciones página 46

OPERATING INSTRUCTION
1.8 Commissioning
1.8.1 Alignment
46 O P E R A T I N G I N S T R U C T I O N | HL18(L), HL18G/HL18T
Table 19: Q1 output ACTIVE states for Dark Switching variants with Alarm/Health and adjustable
time delay
HL18-Xxxxx_
HL18-Yxxxx_
HL18-Jxxxx_
HL18-Kxxxx_
No Time Delay Q1 = D.ON
-xxxxxC
-xxxxxF
Q1 = D.ON
-xxxxxI
1
Adjusta‐
-xxxxxM
ble ON
Delay
-xxxxxI Q1 = L.ON
2
-xxxxxD
-xxxxxG
Q1 = D.ON
-xxxxxK
1
Adjusta‐
-xxxxxN
ble OFF
Delay
-xxxxxK Q1 = L.ON
2
1 L/D Selection Switch in in the "D" Dark Switching position
2 L/D Selection Switch in in the "L" Light Switching position
Red light: Align the sensor with a suitable reflector. Select the position so that the red
emitted light beam hits the center of the reflector. Tip: Use the signal strength light bar
on the back of the sensor to help you align it correctly. The sensor must have a clear
view of the reflector, with no object in the path of the beam [see
ensure that the optical openings of the sensor and reflector are completely clear.
Figure 8: Alignment
figure 8]. You must
8017852.1HW2/2022-11-14 | SICK
Subject to change without notice