12 - USB audio interface functions
4.
After completing the setting, click the "OK" button.
5.
Launch Windows Media Player and start playback to input
the playback sound from the computer to channels 1 and 2
on the Model 12. (MODE switches: PC)
NOTE
i If you change the setting while Windows Media Player is
running, the software will not recognize that the device has
been changed. In this case, restart Windows Media Player.
i If you still cannot hear sound after making the settings and
completing the procedures above, restart the computer.
i If you make this setting, sound will be output through this
unit, but no sound will be output from the computer's
speakers or headphone jack.
Simultaneous ASIO/WDM playback
The driver for this unit can simultaneously play ASIO output
from a DAW and WDM output from Windows Media Player, for
example. The sample rates of both sources must be set to the
same value for simultaneous playback to be possible. Moreover,
the sample rate must also be set to the same value for both
playback and recording in the Windows Sound Properties.
When the sample rates are the same
Example: Windows (WDM) at 44100 Hz, ASIO at 44100 Hz
The Windows audio and ASIO sound are mixed and played
simultaneously.
When the sample rates are different
Example: Windows (WDM) at 48000 Hz, ASIO at 44100 Hz
Only sound from a DAW and other ASIO sources are output.
Sound from Windows Media Player and other WDM sources are
not output.
When the DAW is shut down, for example, and output from ASIO
sources stops, sound from Windows Media Player and other
WDM sources will become audible.
68
TASCAM Model 12
USB audio mode
The sound input to the computer can be changed to allow
the MAIN MIX L/R bus signal to be sent to communication
applications and streaming software.
1.
When the recorder is stopped, select USB AUDIO on the
SYSTEM Screen, and open the USB AUDIO Screen. (see
"Menu operation procedures" on page 29)
2.
Turn the MULTI JOG dial to set USB audio mode.
Option
Meaning
The inputs of channels 1–6, 7/8 and 9/10
MULTI INPUT
and the output of the MAIN MIX L/R bus
(default)
are input to USB channels 1–12.
The output of the MAIN MIX L/R bus is
STEREO MIX
input to USB channels 1–2.
Setting procedures for use with OBS
Studio and other streaming applications
Conduct the procedures in this document before launching the
streaming application.
Model 12 unit settings
1.
Set the MODEL 12 USB audio mode to STEREO MIX. (see
"USB audio mode" on page 68)
2.
Turn the POST REC switch on to enable the MAIN fader for
streamed audio. (see "Analog output adjustment section" on
page 24)
o For Macs, the above settings make use with streaming
applications possible.
Windows computer sound settings
Set the input and output device, sampling frequency, bit rate,
and number of channels according to the setup.
1.
Open the Sound Settings screen.
NOTE
This can also be opened by right-clicking the sound icon
at the bottom right of the desktop screen, selecting "Open
Sound settings" and then selecting "Sound".