Vortice CA MD W EP Serie Manual De Instrucciones página 10

ENgLISH
Caution:
this symbol indicates that care must
be taken to avoid damaging the appliance
An omnipolar switch with a
•
contact opening distance of 3
mm or higher
provided
enabling
disconnection under overvoltage
category III conditions.
Products equipped with single-
•
phase wiring
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines. Any
should
for installation,
complete
(M) engines
kind of modification shall be
considered
tampering and shall nullify the
relative warranty.
No specific
•
necessary
operate at nominal frequencies
without a preliminary setting.
• Thermal protection devices:
- Manual reset thermal protector
The following models are equipped with a manual
reset thermal protector
If the thermal protector is triggered, please contact
qualified personnel or Vortice authorised
Technical Assistance Centre.
If the problem persists after the reset
operation, check the electrical system to which the
unit is connected. In this case, please contact a
Vortice authorised Technical Assistance Centre or
professionally qualified personnel.
be
as product
adjustment
as the devices
is