Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3.7
INSTALL THE PRIMING VALVE
22
7
Use priming valve when using siphon tube.
1.
Before installing the included high pressure hose,
place the priming valve (22) onto the pressure
washer outlet (7) and rotate clockwise until
tightened.
2.
Or directly connect the high pressure hose to the
water outlet (7), when not using the siphon hose.
Water exiting the priming valve is normal. This valve
bleeds air from the pump and will enable the siphon
function.
3.8
INSTALL THE HIGH PRESSURE HOSE
7
1.
Push and turn clockwise one end of the high
pressure hose (13) into the inlet coupler (17).
2.
Install and tighten the other end of the high
pressure hose onto the water outlet (7) coupler.
3.9
CONNECT THE WATER SUPPLY TO THE
MACHINE
For easy operation, please use a self-coiling garden
hose (not provided).
NOTE
WARNING
17
13
English
When you operate the self-coiling hose, make sure
that the hose has no blockage.
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
Always observe all the local regulations when you
connect the garden hose to the water supply. Direct
connection through a receiver tank or backflow
preventer is usually permitted.
Inspect the filter in the water inlet connector before
you connect the garden hose
• If the filter is damaged, do not use the machine
until the filter is replaced.
• If the filter is dirty, clean the filter.
18
1.
Uncoil the garden hose (18).
2.
Let the water flow through the garden hose (18)
for 30 seconds.
3.
Turn the water supply off.
4.
Install and tighten the end of the garden hose
(18) to the water inlet (10) connector.
There must be a minimum of 10 feet of free hose
between the water inlet and the water supply.
10
WARNING
WARNING
WARNING
CAUTION
10
CAUTION
Publicidad
