Publicidad
Idiomas disponibles
Idiomas disponibles
4.5
CHANGE THE SPRAY TIP
WARNING
Before you change the spray tip:
1.
Pull the spray gun trigger to release water
pressure.
2.
Engage the trigger safety lock-out on the spray
gun.
3.
Stop the machine.
4.
Change the spray tip. [See 3.7 ]
WARNING
Do not point the spray wand at your face or others'.
5
MAINTENANCE
WARNING
Before maintenance, make sure that you
• Stop the machine.
• Wait until all the moving parts stop.
• Disconnect the plug from the power source.
WARNING
Do not use strong solvents or detergents on the
plastic housing or components.
WARNING
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
WARNING
Replace the power cord by an approved service
center.
5.1
SPRAY TIP MAINTENANCE
WARNING
Never point the spray wand at your face.
English
5.1.1
REMOVE THE SPRAY TIP
15
21
1.
Pull back the quick-connect collar (21) on the
spray wand (6).
2.
Remove the spray tip (15) from the spray wand
(6).
5.1.2
CLEAN THE SPRAY TIP
1.
Use a straight paper clip or cleaning tool to clean
the spray tip.
2.
Flush and clean the unwanted materials out of
the spray tip with the garden hose.
3.
Install the clean spray tip (18) back into the spray
wand . [See 3.7 ]
6
USE THE PUMP PROTECTOR
Regular use of a commercially available pump
protector prolongs the life of the pressure washer
by removing hard water mineral deposits, lubricating
pump seals and pistons, and preventing freeze
damage. Pump protector (not included) should be
added to the unit after every use and before storage.
Pump protector can be purchased at the retailer
where you purchased your pressure washer, or by
calling customer service.The instructions that follow
are typical for adding pump protector but you should
always verify the specific instructions provided by the
manufacturer of the pump protector used.
1.
Turn off the pressure washer motor pump and
shut off the water supply. Pull trigger to release
water pressure.
2.
Disconnect garden hose and high pressure hose.
3.
Unscrew threaded top from pump protector bottle
and remove paper seal from bottle. Reinstall top
on bottle and tighten securely.
13
6
EN
Publicidad
