Publicidad
Idiomas disponibles
Idiomas disponibles
3.10
INSTALL THE SELF-SIPHON HOSE
The pressure washer can absorb water from
water buckets and containers and from flushing or
stagnant bodies of water.
Exhaust the siphon hose for 30 seconds before
installing the spray tip when using the siphon
function.
1.
Add water to the bucket.
2.
Insert one end of the self-siphon hose (22) into
the water inlet coupler (10). And put the other
end of the self-siphon hose into the bucket (not
included).
10
22
NOTE:When you use the self-siphon hose , you
should do the below instructions:
• The vertical height of the self-siphon hose can't
exceed 4-ft.
• The internal self-siphon hose size is 0.03 ft (10 mm)
- 0.04 ft (12 mm).
• A filter should be installed at the end of the self-
siphon hose into the bucket
English
NOTE
NOTE
3.11
INSTALL THE BATTERY PACK
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
Read, know, and follow the instructions in the battery
and charger manual.
1.
Open the battery lid.
2.
Align the ribs on the battery packs with the
grooves in the battery compartment.
3.
Push the battery packs into the battery
compartment until the batter packs lock into
place.
4.
When you hear a click, the battery packs are
installed.
5.
Close the battery lid.
you can insert one battery or two batteries to start
the machine.
4
OPERATION
Make sure that all the connections are tight and have
no leakage before operation.
11
NOTE
NOTE
NOTE
NOTE
WARNING
EN
Publicidad
