Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10
7
Threaded top
Rubber seal
Paper seal
Pump protector
The rubber seal should remain inside the threaded
top. If it comes out, be sure to replace before
reinstalling the top.
• Unscrew threaded top from pump protector bottle
and remove paper seal from bottle. Reinstall top
on bottle and tighten securely.
• Remove bottle cap and attach threaded end of
bottle securely to pressure washer pump water
inlet (10).
• Squeeze bottle to inject contents into pump.
• With engine switch off, pull starter grip and rope
to cycle pump, then squeeze bottle again to
guarantee complete coverage.
• Pump is protected when the protector fluid exits
the pump outlet.
WARNING
English
7
TRANSPORTATION AND STORAGE
Disconnect the power cord and water supply hose
before transportation and storage.
7.1
MOVE THE MACHINE
• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
7.2
STORE THE MACHINE
Make sure that the spray gun, the high pressure
hose and the machine are dry.
Make sure the machine is out of the reach of
children.
• Disconnect the garden hose from machine.
• Wind the high pressure hose.
• Clean housing and the plastic components with a
moist and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone
number for servicing instructions.
• Store the machine in a dry, isolated and frost-free
area.
14
WARNING
WARNING
WARNING
Publicidad
