Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.1
START THE MACHINE
3
10
18
Do not operate without the water supply connected.
Water exiting the water outlet as the pressure
washer primes is normal. This is needed to bleed
the air from the system.
Before you start the machine:
1.
Turn the water supply on.
2.
Pull the gun trigger to release air pressure.
3.
If a stable stream of water come into view,
release the spray gun trigger.
1.
Install battery pack as previously described.
2.
Press the switch (3) once to start the machine .
3.
Turn the water supply on.
4.
Pull the spray gun trigger.
4.2
STOP THE MACHINE
1.
Release the spray gun trigger (3).
2.
Press the switch, once again, to stop the
machine .
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Remove the battery.
• Pull the spray gun trigger to release the remaining
pressure from the machine.
• Engage the trigger safety lock-out on the spray
gun.
CAUTION
CAUTION
CAUTION
WARNING
English
4.3
USE THE SPRAY GUN
For safe control, keep your hands on the spray gun
at all times.
• Pull and hold the spray gun trigger (19) to start the
machine.
• Release the spray gun trigger (19) to stop water flow
through the spray tip.
4.3.1
UNLOCK THE SPRAY GUN TRIGGER
• Push the trigger safety lock-out (20) down until it
clicks into the slot.
4.3.2
LOCK THE SPRAY GUN TRIGGER
• Push the trigger safety lock-out (20) up and into its
original position.
4.4
ENERGY SAVING FUNCTION
1.
The ECO membrane button (4) is a energy
saving button for the pressure washer. This
button will help to increase usage time by
reducing power.
12
19
20
WARNING
4
Publicidad
