Emerson FLORET ECO Manual Del Usuario página 11

3. Ceiling Fan Assembly
3.14
Route the Wires through the Hanger Ball (Figure 14).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 14).
Pull the Hanger Ball up tight against the Pin and
securely tighten the Phillips Set Screw in the Hanger
Ball (Figure 14).
NOTE: A loose Set Screw could create Fan wobble.
3.15
The Fan comes with Blue, White, Grey, Red, and
Yellow Wires that are 80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 15).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
(Continued)
HANGER BALL
PIN
DOWNROD
Figure 14
INCHES
1/2
INCH
Figure 15
Please contact 1-800-654-3545 for further assistance
11
PHILLIPS
SET SCREW
GREY WIRE
BLUE WIRE
RED WIRE
6 TO 9
WHITE WIRE
YELLOW WIRE
HANGER
BALL
emersonfans.com
ETL Model No.: CF840