REAR BRAKE (DRUM BRAKE)
Adjustment of rear brake pedal
Free stroke 1 of the rear brake pedal refers to the stroke
between the pedal's free position and the pedal's position
when the pedal is stepped down on to brake the rear
wheel.
When adjusting the free stroke 1 of the rear brake pedal,
set the pedal at a comfortable position, adjust the pedal
by rotating the pedal limiting bolt 2 and then rotate the
adjusting nut 3. Turn it clockwise for a smaller free stroke,
or anticlockwise for a larger one. Make the free stroke 1
20–30mm.
NOTE: If follow the steps, the free stoke is not required,
please have it checked by the authorized dealer.
Wear limit of rear brake
There is a wear limit mark on
the rear brake of the motorcycle.
Inspect the wear situation of the
rear brake following the essentials
below.
1. Inspect whether the braking
system
has
been
properly
adjusted.
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
2. Operate the braking system and inspect and make
Riding with worn brake shoes will reduce braking
performance and will increase your chance of
having an accident.
before each use.
qualified mechanic to replace brake shoes if the
shoes are worn to the limit.
TIRES
Periodic checks should be performed for tire pressure
and tire wear status. To ensure maximum safety and
life, check the tire frequently, in addition to the scheduled
inspections.
Tire pressure and wear status are very important
for the performance and safety of the motorcycle.
Be sure to check tire pressure and tire wear status
The mark
regularly.
extending line is in
the allowed range
41
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
sure the mark extending line 1 is in the allowed range
3 (see the figure) marked on the wear limit mark
2, otherwise have the component in the rear brake
replaced by a qualified distribution and maintenance
organization for safety.
BWARNING
Inspect brake shoe wear
Ask your Haojue dealer or a
BWARNING
(101)
EN
(101)