Publicidad
Idiomas disponibles
Idiomas disponibles
help of the stand.
2. Remove the engine oil dipstick 1.
3. Place a drain pan below the engine. Dismantle the
drain plug 2 and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2 and its washer.
5. Fill 1000 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again 1.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
level should be between the UPPER LEVEL and the
LOWER LEVEL.
BCAUTION
Use
the
engine
oil
"Instructions for use of fuel and engine oil".
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
The engine oil
recommended
in
the
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
Engine oil strainer
Regularly replace the engine oil strainer as instructed in
the "Table of Regular Maintenance". The replacing steps
are as follows.
1. Completely drain the original engine oil as instructed
in section "Engine oil replacement".
2. Dismantle the engine oil strainer cap 1 and take out
the spring 3 and the engine oil strainer 4.
NOTE: Do not lose the seal ring 2 on the engine oil
strainer cap.
3. Clean and inspect the engine oil strainer and, if it is
damaged, replace it.
4. Install the spring, the engine oil strainer and the engine
oil strainer cap.
NOTE: Do not lose the seal ring 2 on the engine oil
strainer cap.
5. Add the specified new engine oil into the engine as
instructed in section "Engine oil replacement".
35
(95)
EN
(95)
Publicidad
