Haojue TZ150 2019 Manual De Uso página 73

RIGHT HANDLE SWITCHES
ENGINE STOP SWITCH 1
The engine can only start up
when the switch is placed at the
"*" position, and the ignition
circuit is connected. If the
switch is at the "%" position, the
ignition circuit is cut off. This is
an emergency stop switch.
LIGHT SWITCH 2
"+" position
The headlight, front position light, dashboard lights, tail
light will be turned on together.
"6" position
The front position light, dashboard lights, tail light will be
turned on together.
"&" position
All lights mentioned above will be turned off.
ELECTRIC STARTUP BUTTON 3 #
This button is used for operating the starter motor. With
the ignition switch at the "*" position, the engine stop
switch at "*" and the transmission in neutral, grasp the
clutch lever and push the electric starter button # to
operate the starter motor to start the engine.
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
Engaging the starter motor for five seconds at
a time can damage the start motor and wiring
harness from overheating.
Do not engage the starter motor for more than five
seconds at a time. If the engine does not start after
several attempts, check the fuel supply and ignition
Accelerate
system.
section in this manual.
When cleaning the motorcycle, do not directly
clean its electric parts, particularly its handle
switch.
Do not use the electric start function and the kick
lever function at the same time.
Do not start the motorcycle when the fuel or engine
oil is insufficient.
FRONT BRAKE LEVER 4
The front brake is applied by grasping the brake lever
gently toward the throttle grip. The brake light will be alight
when the brake lever is grasped inward.
13
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
BWARNING
Refer to the "TROUBLESHOOTING"
BWARNING
BWARNING
BWARNING
(73)
EN
(73)