Publicidad
Idiomas disponibles
Idiomas disponibles
(96)
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
BCAUTION
It is suggested to replace the seal rings when the
engine oil strainer is replaced.
CLUTCH
Method to inspect the clutch cable gap 4: remove the
EN
rubber bush 1 along the clutch cable, operate the clutch
handle and make sure there is a gap of 3–5mm before
there is an apparent resistance. If the gap is insufficient,
adjust it with the method below.
1. Remove the rubber bush 1 along the clutch cable,
loosen the nut 2.
2. Turn the adjusting screw 3 clockwise till the end.
3. Loosen the lock nut 5, adjust the nut 6 along
the front-back direction, operate the clutch lever and
adjust the clutch cable gap 4 to be 3–5mm.
(96)
Haojue TZ150/TZ150S 99011H36622H000 V03 ES+EN 2019-8-26
4. Do fine adjustment through the adjusting screw 3.
5. Firmly lock the nut 2 and 5, and then mount the
rubber bushes 1.
BCAUTION
Excessive clutch cable play can easily result in
wear and faults in the clutch and the gear shift
lever. If the clutch cable gap is not correct (the gap
4 exceeded the range of 3–5mm), or the clutch is
slipping or accelerating weakly, adjust the cable on
time. It is forbidden to intentionally adjust the gap
4 that exceeded the range.
CARBURETOR
Stable carbureting evaporation is the most fundamental
requirement for the carburetor.
evaporation has been accurately set in the factory. Please
do not change its setup. You only need to pay attention to
two things: idle and throttle cable free-play.
Adjustment of idle speed
1. Start the engine, keep it running
at idle till fully pre-heated.
2. After the engine has been pre-
heated, release the throttle, turn
the adjusting screw to right and
left to keep the engine revolving speed between 1400–
1600 rpm.
36
The carbureting
Publicidad
