Publicidad
Idiomas disponibles
Idiomas disponibles
5 GATEWAY SETUP
5.1 REGISTERING GATEWAY ON WEG MFM
NOTE!
In this first step of the Cassia X2000 gateway setup, the device does not have to be turned on. For
the next steps, the gateway must be turned on.
NOTE!
In order to register the gateway on the platform, the customer must have already registered a user,
password and the plant in which the gateway will be used on the WEG MFM platform.
The gateway must be added to the WEG Motion Fleet Management <mfm.wnology.io>, in the manufacturing plant
of interest. To that end, you must already have access to the MFM platform and have the manufacturing plant
where the gateway is installed registered.
On the upper left corner of the MFM main page, click on "Manage" and then on "Register".
Once on the registration page, select "WEGscan & Gateways" on the left tab of the page. Options for registering
sensors and gateway will appear. Select "Gateway".
Figure 5.1: Tab on the upper left corner of the MFM main page
Figure 5.2: MFM sensor and gateway registration page
Gateway Setup
Gateway Cassia X2000 | 23
Publicidad
