Publicidad
Idiomas disponibles
Idiomas disponibles
Gateway Setup
In the gateway registration fields, all of which are mandatory, you must enter:
Name
Plant
MAC Address
Model
After filling in the fields, click on Save. This will register the gateway on the MFM platform so that it can connect
to the system, allowing data exchange between the platform and the Bluetooth sensors.
5.2 ACCESS THE GATEWAY HOMEPAGE
Once configured in the WEG Motion Fleet Management platform, we can proceed to the next step, which is to
access the gateway home page. To that end, we need to choose the best gateway access connection for the
user, either via ethernet or via Wi-Fi.
5.2.1 Via WI-FI
To access the homepage via Wi-Fi, the computer must be connected to the Wi-Fi network generated by the gateway.
The Wi-Fi network will have a name starting with "cassia" and will continue with the final 6 digits of the product
MAC, such as "cassia-E27240". The Wi-Fi network password will be the same as the network name, which in this
case is "cassia-E27240".
NOTE!
If the Wi-Fi network generated by the gateway is not visible to your computer or any other Wi-Fi device,
reset the Cassia X2000 gateway to its factory settings by pressing the reset button located at the
bottom of the product for 15 seconds. The Wi-Fi network should appear with the default name above.
24 | Gateway Cassia X2000
Table 5.1: Gateway registration fields on the MFM platform
This name will identify your gateway in the plant. Use a name through which you can
easily identify the gateway in case there is more than one gateway in the plant
Select the manufacturing plant where the gateway is or will be installed
You will find the Cassia X2000 MAC address on a label on the bottom of the product,
between the two Bluetooth antenna connectors
Enter X2000, corresponding to this manual and product
Figure 5.3: Page for the gateway registration on the MFM platform
Publicidad
