Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL
Description of indicator lights
• In normal situation, Power, MPPT and V (voltage) indicator lights turn on at the same time;
• If there is no water in the well, the MPPT indicator light will turn off. Then the well indicator light (Well) will
turn on and the motor will stop operating.
• If the tank is full, the MPPT indicator light will turn off. Then, the tank indicator light (Tank) will turn on and
the motor will stop operating.
Description of fault codes
When a fault occurs, the motor will shut down and the corresponding fault code will appear on the controller
display.
Storage
• The motor pump should be stored in a dry, well-ventilated place and without corrosive substances;
• If it is necessary to store the equipment after use, drain the water from the pump and dry its surfaces before
storing.
52
Indicator light
A
W
RPM
V
Fault
Full tank
Impeller stuck
Broken MOSFET
Overload
Dry well
Overcurrent
Undervoltage
Motor phase loss
Phase-to-Ground Short Circuit
Overvoltage
Table - Fault codes
EBARA BOMBAS AMÉRICA DO SUL LTDA.
3BPS ci/ce and 4BPS ci
Parameter displayed
Input electrical current
Input electrical power
Motor rotation
Input voltage (Vdc)
Code displayed non-viewer
E2
E3
E4
E5
E6
E7
E8
E9
E10
E11
Models
Publicidad
