Domo DO266A Manual De Instrucciones página 62

Drain code P1
When you don't use the permanent drain, the non recycled
condensation water, will be stored in the water tank.
· When the water tank is full a few beep signals will be heard and
on the display the code P1 will appear. The "cool" or "dry" mode
will end automatically. The fan will continue to operate, this is
normal.
· Move the unit over to a place where you can easily drain the
water.
· Remove the drain plug at the bottom of your unit (A) and drain
the water.
· After fully draining the water tank, place the drain plug back on
the drain opening.
· Restart the unit, make sure the error code P1 is no longer
displayed. When the code doesn't disappear, try turning off and
on the unit a few times. When the error code continues, please
contact the after sales service.
· NOTE : always make sure to install the drain plug, before turning the unit back on.
CLEANING
· Always remove the plug from the socket before cleaning the unit.
· Never use any chemical or abrasive products to clean the unit.
· Never clean the unit with water or any other liquid, this can cause electrocution.
· When the power cord is damaged it must be repaired or replaced by the after sales surface
of the manufacturer or by a qualified person.
Air filter
· Clean the air filter at least ever 2 weeks. To make sure the
air conditioning can operate in optimal conditions.
· Clean the air filter in lukewarm water with a bit of
detergent. Rinse the filter thoroughly and let it dry.
· Make sure the filter is completely dry before placing it
back in to the air conditioning.
Air conditioning body
Use a damp, soft cloth and a bit of mild detergent, to clean the outside of the unit. Make sure
the unit is thoroughly dried afterwards.
62
DO266A
A