Publicidad
Idiomas disponibles
Idiomas disponibles
1. Attach the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips screws
provided. (Figure A)
2. If equipped with automatic climate
controls, secure the climate module
removed in Dash Disassembly, to
the radio brackets, using the factory
hardware. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, and then secure it using the
screws supplied with the radio.
(Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
6. Place the radio trim panel over the radio
assembly, then reassemble the dash in
reverse order of disassembly.
KIT ASSEMBLY
(Figure A)
(Figure B)
(Figure C)
REV. 3/6/2019 INST99-7617B
3
Publicidad
