Interface; Operating; Usb Interface; Rs-232 Interface - WIKA Mensor CPC2000 Manual De Instrucciones

7. Interface

7. Interface
Version key for firmware and operating instructions
EN

Operating

instructions
2.1.0
It is possible to control and monitor the controller via a PC using interfaces (USB or
RS-232). In Control, Measuring and Automatic mode, a cyclical output of the current
instrument status can be switched on and off. Output interval for this is 1 second.
7.1

USB interface

The PC provides a virtual COM port over the USB interface. The control of the instrument
is therefore no different from the control via the RS-232.
7.2

RS-232 interface

To connect, the RxD, TxD and GND lines are required. The connection is made with an
in-line serial cable (1:1, male/female).
7.3

Interface configuration

To access and set the interface configuration, proceed as follows.
1. Press the [MENU] button.
2. With the [▲] or [▼] buttons, select the menu item SETTINGS.
3. Confirm with [SELECT].
4. In the submenu item, select the item RS232/USB with the [▲] or [▼] buttons.
5. Confirm with [SELECT].
RS232/USB
-------------------------
ACTIVE.....
BAUD......:
DATA-BITS.:
STOP-BITS.:
PARITY-BIT:
30
Firmware
1.32
RS232
9600
8
1
N
RS232/USB
-------------------------
ACTIVE....:
BAUD......:
DATA-BITS.:
STOP-BITS.:
PARITY-BIT:
WIKA operating instructions, model CPC2000
USB
9600
8
1
N